Novamatic FH68-VCU Manuel d'utilisateur Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
You cannot activate the ap-
pliance.
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
You cannot activate or oper-
ate the hob.
The oven does not heat up.
The fuse is released. Make sure that the fuse is the
cause of the malfunction. If
the fuse releases again and
again, contact a qualified
electrician.
The oven / hob display
shows an error code that is
not in this table.
There is an electrical fault. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
You cannot activate or oper-
ate the hob.
The fuse is released. Activate the hob again and
set the heat setting in less
than 10 seconds.
Residual heat indicator does
not come on.
The zone is not hot because
it operated only for a short
time.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation set-
tle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
It takes too long to cook the
dishes or they cook too
quickly.
The temperature is too low or
too high.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
19
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Commentaires sur ces manuels

Pas de commentaire