Novamatic KSTF315-IB Manuel d'utilisateur télécharger pdf (Page 58)

GB GB

How to save energy

Avoid putting the appliance in a sunny place near any-

thing that gives off heat.

Be sure that the condenser and the compressor are

well ventillated. Do not cover the sections where venti-

lation is.

Wrap products in tightly closing dishes or cling film to

avoid bulding up unnecessary frost.

Do not leave the door open longer than necessary and

avoid unnecessary openings.

Put warm foods into the appliance only when they are

at room temperature.

Keep the condenser clean.

The appliance and environment

This appliance does not contain gasses which could dam-

age the ozone layer, in either its refrigerant circuit or insu-

lation materials. The appliance shall not be discarded

together with the urban refuse and rubbish. Avoid damag-

ing the cooling unit, especially at the rear near the heat

exchanger. Information on your local disposal sites may

be obtained from your municipal authorities.

The materials used on this appliance marked with the sym-

pol are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chambers in form

of frost and goes with the operation of the appliance.

Thick frost and ice has an insulating effect, so it reduces

cooling efficiency as the temperature increases in the

cooling chambers, they need more energy.

At this type of appliance defrosting the cooling surface of

the refrigerator is automatic without any external interven-

tion. The thermostatic control interrupts the operation of

compressor at regular intervals for more or less time - dur-

ing this cooling is interrupted - the temperature of the

cooling surface goes above 0 °C due to interior heating

load of the compartment, so defrosting occurs. When the

surface temperature of the cooling surface has reached

+3 °C- +4 °C the thermostatic control restarts operation

of the system.

Melting water flows through defrost water outlet leaded

through the back into the evaporator tray maintained on

the top of compressor and evaporates due to its warmth.

Check and clean the outlet of melting water

coming during defrosting regularly - a label

inside the appliance warns you for this. If it is clogged

the melting water gathered can cause earlier failure

as it can go to the insulating of the appliance.

Clean the melting water outlet with the supplied pipe

scraper that can be seen in the figure. The pipe scraper

has to be stored in the outlet.

The most typical case of clogging up in the melting water

outlet when you put hot food wrapped in some paper into

the appliance and this paper contacts back plate of the

refrigerator and freezes to it. If you remove the food right

at this moment the paper will tear and it can cause clog-

ging up in the outlet by getting into it.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Novamatic KSTF315-IB Manuel d'utilisateur Page 58

Commentaires sur ces manuels

Produits connexes et manuels pour Glacières Novamatic KSTF315-IB